2606B System SourceMeter® Instrument Reference Manual
Section 5: Remote commands
2606B-901-01 Rev. B / May 2018
5-7
The following standard I/O commands are not supported at this time:
File
I/O
fileVar
:lines()
fileVar
:setvbuf()
io.lines()
io.popen()
Instrument identification
These commands store strings that describe the instrument.
(on page 7-139)
(on page 7-144)
(on page 7-145)
LAN and LXI
The LAN commands have options that allow you to review and configure network settings.
The
lan.config.*
commands allow you to configure LAN settings over the remote interface. Note
that you must send
lan.applysettings()
for the configuration settings to take effect.
The
lan.status.*
commands help you determine the status of the LAN.
The
lan.trigger[
N
].*
commands allow you to set up and assert trigger events that are sent over
the LAN.
Other LAN commands allow you to reset the LAN, restore defaults, check LXI domain information,
and enable or disable the Nagle algorithm.
(on page 7-112)
(on page 7-113)
(on page 7-114)
(on page 7-117)
(on page 7-117)
(on page 7-118)
(on page 7-120)
(on page 7-121)
(on page 7-121)
(on page 7-122)
(on page 7-122)
(on page 7-123)
(on page 7-124)
(on page 7-125)
(on page 7-125)
(on page 7-126)
(on page 7-127)
(on page 7-127)