Starter Kit Instruction Manual
Page
7
of
9
www.KegLand.com.au
Last Updated 1/30/2018 8:44 PM
2.
Once the threaded spigot
sticks out the bottom of the
FermZilla use the thread ring
to secure the spigot onto the
tank.
NOTE
: This is a
LEFT HAND
THREAD
. This has been
designed with a left hand
thread so it does not come
undone when you tighten the
Butterfly Valve Assembly onto
the Dump Valve Adaptor. Do
up the Thread Ring hand
tight. This should be all that
is required to get a good seal.
(see right) This has been
designed so that when
pressure increases inside the
tank the seal pushes harder
against the tank. For this
reason it is not important to
overtighten this part of the fermenter.
3.
Locate the butterfly dump valve and screw this onto the spigot. This is a
RIGHT HAND
THREAD
. Screw this onto the spigot firmly. Once again do not over tighten this fitting as
additional tightness will not improve the sealing performance.
NOTE: When the handle on the butterfly dump valve is horizontal the gate is closed. When the
handle is in the vertical position the gate is open.
