BrewZilla 35L - Gen 4 Instruction Manual
Page
21
of
31
Last Updated 22/03/2022 16:53 PM
bladder and then simply leave it at ambient temperature for 24 hours to cool down
(preferably out of direct sunlight).
Cleaning
Cleaning after the brew day
The Gen 4.0 BrewZilla has a domed bottom with a centralised pump inlet. This makes it easy
to drain all liquid from the brewery at the end of your brew day simply by opening the tap.
After the liquid has been drain then rinse to remove any trub from the boiler. You may find
tipping the unit upside down will do a better job at getting all this trub out of the boiler.
Then fill your brewery up with water and an approved cleaner such as
according to the instructions on the package. Set the temperature on the boiler to 55°C and
attach the camlock recirculation arm. Then select play on the device to energise it and
recirculate this cleaner for 10 minutes using the pump, particulates on the wall of the
brewery can be removed using a sponge or cloth. Then turn the pump off and connect your
chiller (if required) and recirculate through the chiller for another 5 minutes.
Then the pause button to turn the elements and pump off, empty the cleaning liquid and
rinse the brewery using a hose or fill with clean water. Attach the recirculation arm and
press play to reenergise the device and run the pump to rinse the recirculation arm and
repat with your chiller (if required).
After it has been rinsed, empty this water and then fill again with water and an approved
according to the package instructions. Acidic sanitisers such as
StellarSan assists with dissolving minerals which produce beer stone and also helps to
passivate the stainless steel. Recirculate this StellarSan solution through the camlock
recirculation arm and the chiller (if required). The StellarSan solution can then be emptied
ready for the next brew day, it does not require rinsing.
