Operation
Slim Jim Idrocompresso User manual
page 21
Sub-menu WATER TIMER
In the sub-menu water timer you can adjust the following:
parameter
range
factory
increment
unit
remark
water dispense
0.5 .. 15
4.0
0.1
s
pump on-time Gr1
5 .. 59
7
1
s
can be set per
individual group
pump on-time Gr2
pump on-time Gr3
not in Duette
flush time
1.0 .. 10
2.0
0.1
s
Note!
pump on-time is the duration the optional pump is active after taking the lever out of resting
position.
Sub-menus TIMED ON/OFF and TIME/DATE
In the sub-menu timed on/off you can adjust the following:
parameter
range
factory
remark
auto off
NO, to NO HEAT, to ECO-all
NO
turn automatically to stand-by
off time
hh:mm
time to turn to stand-by
auto on
NO, YES
NO
turn automatically ON
on time
hh:mm
time to turn ON
day off
none, Monday .. Sunday
none
skip a weekday to turn automatically ON
This sub-menu continues into the sub-menu TIME/DATE.
In the sub-menu time/date you can adjust the following:
parameter
range
factory
increment
unit
remark
shot time
-1 .. 99
20
1
s
-1 never show shot time
0 show shot time during brew only
present time
hh:mm
make sure to set correctly and
check time and weekday regularly
present weekday
Mon..Sun
Timer function to switch the machine
The machine can automatically change state:
•
Using the “auto off” function will turn the machine to stand-by (NO HEAT or ECO) at a pre-set
time (e.g. at the end of the day). It is especially meant to facilitate the use of the ECO function.
•
Using the “auto on” function will turn the machine to operational temperature at a pre-set time
(e.g. in the morning). When set correctly, the machine will be fully operational the minute you
walk-in or the store opens.
•
The “day off” function will make the pre-programmed ON time skip a day.
You can manually override an automatically set switch at any time. After such interference the timer
function continues in the background and will perform the next pre-set action when it turns up.
Notes!
To have the machine react properly to the timer function instructions the main and heat switches must
remain in the ON position.
The time and weekday of the controller must also be set correctly. It is advised to check these
regularly (present time and weekday are shown on the ECO-all and NO HEAT windows).
