KeeNetic Lite KN-1310, Command Reference Manual

Page: 174 / 320

Change settings Yes
Multiple input No
Interface type IP
Synopsis
(config)>
ip http ssl enable
(config)>
no ip http ssl enable
Example
(config)> ip http ssl enable
Http::SslServer: SSL server was enabled.
History
Version Description
The ip http ssl enable command has been introduced.
2.07
3.31 ip name-server
Description Configure DNS server IP-addresses. Addresses saved in this fashion are called
static as opposite to dynamic — as registered by PPP or DHCP services.
Active, that addressed being used are the ones that have been registered
most recently as compared to the others. Usually, the system uses the
addresses which were obtained by several recent successfully connected PPP
or DHCP services. If none of the services registers DNS addresses, static
settings will be active. However, if after registering dynamic addresses the
static settings are changed by the user, they become active until the new
dynamic addresses are registered.
ip name-server command can be entered multiple times if several DNS-server
addresses need to be setup. Moreover, each entered address can be
associated with one or more domain names for working with specific areas,
such as local names in the corporate network.
Command with no prefix removes the specified DNS server address from the
static and the active lists if the command is furnished with arguments. If you
use no arguments, the entire list of static addresses will be removed.
Prefix no Yes
Change settings Yes
Multiple input Yes
Synopsis
(config)>
ip name-server
‹
address
› [ ‹
domain
› [
on
‹
interface
› ] ]
(config)>
no ip name-server
[ ‹
address
› ] [ ‹
domain
› [
on
‹
interface
› ] ]
Command Reference Guide — Keenetic Lite (KN-1310)
174
Chapter 3 Command Reference