EXPRESSION PEDAL INPUT
You must use a TRS (stereo) expression pedal with the
ECCOS. If you use a mono cable (or volume pedal), the
ECCOS will not power on.
When a TRS (stereo) expression pedal is inserted, the
expression pedal defaults to controlling the BLEND
control of the delay.
Note: Plugging a mono cable into the TRS EXP. PEDAL
jack will allow the control of the FDBK switch with a
momentary switch.
CLEAR ALL EXPRESSION SETTINGS
To clear ALL expression pedal settings, enter Expression
Pedal Mode by holding FDBK for 2 seconds. Once in
Expression Pedal Mode, hold BYPASS for 2 seconds to
clear ALL expression pedal settings and reset them to
default. Once finished, exit Expression Pedal Mode by
holding FDBK for 2 seconds.
13
ECCOS DELAY/LOOPER
EXPRESSION PEDAL USE
TO ASSIGN A PARAMETER
1. Hold FDBK for 2 seconds to enter Expression Mode.
2. Set connected expression pedal to heel-down.
3. Turn an ECCOS control knob to the desired
heel down setting.
4. Set the expression pedal to toe-down.
5. Turn the same control knob to the desired
toe-down position.
6. Hold FDBK for 2 seconds to save your settings.
Note: You can set multiple parameters at once to be
controlled with your expression pedal. You can set
partial ranges, reassign ranges, or even reverse heel/toe
positions in this mode. The sky is the limit!
TO UNASSIGN A PARAMETER
1. Hold FDBK for 2 seconds to enter Expression Mode.
2. Set connected expression pedal to heel-down.
3. Turn each knob a small amount to let the ECCOS knob
you don’t want the control to be ‘expression controlled’.
Don’t touch controls still assigned to the expression pedal.
4. Set the expression pedal to toe-down.
5. Hold FDBK for 2 seconds to unassign and save.
Note: Any parameters that were not moved will maintain
their previous expression status.
Note: You can save expression pedal setting to any of
the 3 ECCOS preset locations.
Summary of Contents for ECCOS
Page 1: ...INSTRUCTION MANUAL ...