Keeler Pulsair Intellipuf, Instructions For Use Manual

Page: 19 / 132

15 EN
Pulsair Intellipuff Tonometer by KEELER
3. To change the User Option, press the OD OS
/ ‘Menu Change’ button once, ‘toggling’ the
OD OS / ‘Menu Change’ button will cycle
through the option(s).
4. Pressing the Print / Menu button will move
you forward to the next User Option, in this
case the Buzzer Control.
5. Use the OD OS / ‘Menu Change’ button to
make your preferred selection.
Note: to run the Self-test, press the DEMO
button, not the OD OS / ‘Menu Change’
button.
6. Continue to repeat steps 4 and 5 until ‘OK’ is
displayed. Your Pulsair IntelliPuff Tonometer is
now ready to use with your preferred settings.
Menu Option Display Change Options
Printer Control PRNT OFF / ON
Buzzer Control BUZ ON / OFF
IOP Format XX / XX.X
Full Self-test RUN TEST TEST / WAIT
The last choice above ‘Run Test’ (selected by pressing DEMO button) would start a Self-
test program (around 45 seconds), the result of which should be printed.
13. CALIBRATION, MAINTENANCE AND INSPECTION
Keeler recommends this routine maintenance be carried out by the user
frequently to ensure safe and accurate measurement. In the event of
the device being outside of the calibration tolerances, it is important to
send the device back to Keeler Ltd. or your local dealer for repair and
re-calibration.
13.1 REGULAR INSPECTION
Inspect your power supply unit and cable for damage regularly.
Before inspecting, disconnect the power supply from the Pulsair IntelliPuff Tonometer and the
mains.
If the outer insulation of the cable appears to be damaged discontinue use immediately.
Contact your local dealer for a replacement.
OD OS / ‘Menu
Change’ button
Print / Menu
button
Demo
button