KEDDY Christineberg, Installation Instructions Manual

Page: 6 / 20

- 4 -
INSTALLATION INSTRUCTIONS
Before starting on the installation of the tile stove, the following steps need to be fully completed:
• Chimney:
Alternative 1 - An existing chimney prepared for rear connection
Alternative 2 - A newly installed chimney prepared for rear connection
Alternative 3 - Prepared for a new top connected chimney.
• Load-bearing surface
• Outdoor air supply
(if so required)
• Floor protection
• Fire retardant wall panels
• Painting of wall panels
3. Place four element 2 pieces with matching gaskets
on top of the bottom elements.
Place round gasket spacers evenly distributed on all
sides, four spacers per course, eight pieces in total.
Push the elements outwards against the safety case, so
the spacers are kept in place.
SAFETY CASE
1. Push the big middle circle out of the template. Place
the template against the fire retardant wall at the rear,
see illustrations 2a and 2b on page 3.
Secure the template firmly with tape. It should remain
as protection until the installation of the tile stove is
completed.
For outdoor air connection from below, close the rear hole
in the bottom safety case with the plug supplied.
Put a substantial silicone sealant (transparent) round the
bottom hole in underside of the bottom safety case. Place
the safety case in the hole punched into the template.
Adjust the safety case before the silicone hardens so
the arrow marking agrees with the centre marking on
the template.
If a rear outdoor air connection is required, connect it now.
HEATING MAGAZINE AND HEARTH
The installation of the heating magazine and the hearth
can now be started inside the safety case. They are both
installed from above, and via the cast iron door.
2. Insert the two bottom elements, marked with 1 , centred
against the gaskets at the bottom of the safety case. Put
the two matching gaskets on top.