1. INITIAL PREPARATION
Insert batteries into the Remote Control unit by following the procedure described in the
"REMOTE CONTROL BATTERY INSTALLATION" section in this manual.
Follow the procedure described in the "MENU OPERATION" and "AUTO PROGRAM"
sections that follow to automatically scan and store active television channels into memory.
2. BASIC OPERATION PROCEDURE
1. Lowering the LCD Screen releases the AUTO POWER
SWITCH (see item #10 on page 8) and turns power on.
The input source last viewed will be automatically
selected.
If the screen is already lowered but power has been
turned off manually (or by the AUTO POWER OFF
function), press the POWER button on the LSM104
Control Panel or remote control to turn power back on.
2. Press the TV/VIDEO button on the LSM104 Control
Panel or Remote Control to select the desired mode
(TV, VIDEO 1, VIDEO 2, VIDEO 3).
3. If TV mode has been selected, select the desired channel using the CHANNEL /
but-
tons on the LSM104 Control Panel or Remote Control. Pressing the /
buttons
advances to the next lower or higher channel stored in memory.
Channels can be selected directly by using the 10-digit Keypad on the Remote Control.
Example: To select Channel 5, press "0" first, than press "5". (If "0" is not pressed first,
there will be a delay of about 5 seconds before the channel changes.)
4. If external speakers are connected to the EXTERNAL SPEAKERS OUTPUT CONNEC-
TOR, the VOLUME
-
/ + buttons on the Remote Control may be used to adjust the speak-
er's volume.
The volume level will be shown on the screen with a
bar scale and a reference number (0-100) as shown.
16
LSM104 OPERATION
NOTE : The volume level can be muted instantly by pressing the MUTE button on the Remote
Control. See "MUTE Button" on page 25.
(1)
(3)
(4)
(4)
(3)
VOLUME 33
(2)
1. LSM104 INSTALLATION
EXAMPLE(Using optional mounting bracket)
Install the unit with 4 screws.
Use extreme care to insure that tools do not
damage the unit.
Use extreme care to insure that cutting tools
and/or mounting screws do not contact, cut or drill
through exterior body panels.
When the components are mounted with screws, be certain that the minimum thickness of the mount-
ing material is as follows:
Wood
: 10mm or more
Metal
: 3mm or more
Plastic
: 4mm or more
2. LSM104 CUTOUT DIMENSIONS
A cutout template is packaged with this unit.
15
SET UP FOR CAR USE
NOTES:
The DC Power plug should not be accessible to the consumer.
WARNING:
UNDER NO CONDITION SHOULD THE LCD DISPLAY BE MOUNTED IN ANY POSITION WHERE A
PICTURE MIGHT BE VISIBLE TO THE DRIVER. EVEN IN THOSE CASES WHERE SUCH AN
INSTALLATION IS NOT PROHIBITED BY LAW, DOING SO MIGHT INCREASE THE LIKELIHOOD
OF A SERIOUS ACCIDENT.
394
2-R610.5
2-R126
2-R86
176
377
379
227
292
