![background image](http://html.mh-extra.com/html/kec/kt-lcd3/kt-lcd3_user-manual_660516024.webp)
ELECTRIC BICYCLE METER KT—LCD3 Product User Manual
- 23 -
1.
○
Exit P Parameter Setting
Among the five P parameter settings, when each parameter setting is completed, if
held
button (
SW
) long for about 2 seconds, all can exit the setting environment and
return to display 1, meanwhile, the current set parameters would be saved.
Under each parameter setting interface, if there’s no button operation on the meter for
more than 1 minute, and then the meter will automatically return to display 1, and the
original set parameters will be saved.
C Parameter Setting
After finishing P5 parameter setting, P5 parameter column stops flashing. Within 1
minute after stopping flashing, hold
button
(UP)
and
button
(DOWN)
for
about 2 seconds to enter C parameter setting environment.
○
C1 Power Assist Sensor and Parameter Select Mode
Set C1 parameter first after entering C parameter setting environment, C1 parameter
column flashes.
C1 parameter setting interface
C1 is power assist sensor and parameter select mode. Its definition is shown in
following table. C1 setting ranges between 0-7, hold
button
(UP)
or
button
(
DOWN
) for selection.
C1 parameter definition table
:
KUNTENG power assist
sensors
C1
value
Start
Sensitivity
KUNTENG V12
power assist sensors
C1
value
Start
Sensitivity
Forward 5 Signal
00
Standard
Reverse 6 Signal
05
Standard
01
Lower
06
Lower