8
Maintenance
The device will not trigger any error messages. Faulty devices must be ex-
changed and shipped to KEBA for repair.
8.1
Firmware update
New firmware versions can be loaded via the RS-485-A interface (SI0) or via
the graphic interface (graphics). The procedure is described in the installation
manual of the control systems.
CAUTION
Defective operating panel by interruption of the power supply during firmware
update!
●
The power supply may not be interrupted during the update!
During the firmware update, the firmware is written to the flash storage of
the operating panel within seconds. If the update procedure is interrupted
exactly during this period, the operating panel will be rendered inoperable
and must be sent to KEBA for repair.
8.2
Packaging, shipment
The device is wrapped into protective packaging material for shipment. For
reasons of environmental protection KEBA appreciates receiving the original
packaging material for multiple use.
The protective packaging does not qualify as adequate transport packaging
and hence is not suited for transportation via carrier haulage or airplane. Ap-
propriate transportation packaging is required for these types of shipment.
8.3
Cleaning the touch screen
The surface should be cleaned with a moist, clean, soft cloth and glass cleaner.
The glass cleaner should be sprayed onto the cloth and not directly onto the
surface.
The surface coating of the touch screen is resistant to the following solvents:
Solvent
Heptan
Alcohol
Toluene
Acetone
Methyl ethyl ketone
Unleaded gasoline
Hydrochloric acid
Turpentine
Gear oil
Oil SAE
Diesel
Antifreeze
Isopropanol
Maintenance
OP 350/C-1100
© KEBA 2009
Project engineering manual V2.00
36
Summary of Contents for Kemro OP 350/C-1100
Page 4: ......
