1.3
Intended use
The MM 280/A was developed for control applications in industrial machines.
The typical applications areas include injection molding machines, robots,
presses, machine tools and similar.
The MM 280/A may only be used for the types of use described in the technical
descriptions and only in conjunction with recommended/approved third-party
equipment/installations.
The MM 280/A has been developed, manufactured, tested and documented
in accordance with the appropriate safety standards. Therefore, the products
do not pose any danger to the health of persons or a risk of damage to other
property or equipment under normal circumstances, provided that the instruc-
tions and safety precautions relating to the intended use are properly observed.
1.4
Notes on this document
This manual is integral part of the product. It is to be retained over the entire
life cycle of the product and should be forwarded to any subsequent owners
or users of the product.
1.5
Documentation for further reading
The following documents are to be observed depending on the system solution
used:
If you are using the KeStudio U2 tool suite:
Doc.No.
Name
Target group
DE: 65352
EN: 65353
K2-200 automation system manual
●
Project engineer
●
Electrician
●
Programmer
●
Commissioning foreman
●
Service technician
If you are using the KeStudio U3 tool suite:
Doc.No.
Name
Target group
DE: 1000868
EN: 1000869
System manual Kemro automation
system
●
Project engineer
●
Electrician
●
Programmer
●
Commissioning foreman
●
Service technician
Introduction
MM 280/A
© KEBA 2011
Project engineering manual 1.04
8
Summary of Contents for Kemro MM 280/A
Page 4: ......