P30
Authorization
Operating instructions V3.22
20
© KEBA
5.2.3
Teaching in the slave card
The RFID slave card can be used to authorize a charging procedure. The
RFID master card is required to teach in an RFID slave card.
No charging session may be active for the teaching in and no vehicle may
be connected to the charging station. The LED bar must flash blue.
To teach in the RFID slave card, proceed as follows:
1) Hold the RFID master card in front of the RFID reader until a signal tone
sounds.
2) Within 3 seconds hold the new RFID slave card to be taught in front of
the RFID reader. A successful programming process is confirmed by a
rising tone sequence.
3) Confirm the teach-in process within 3 seconds by holding the RFID mas-
ter card in front of the RFID reader again. The procedure is concluded
by a further rising tone sequence.
The LED bar then flashes blue to indicate that authorization to start a charge
is required.
5.2.4
Deleting RFID cards
In some cases, it is necessary to delete the taught-in RFID cards. For exam-
ple, after loss of an RFID card or in oder to charge without authorization. It is
only possible to delete all taught-in RFID cards; deleting a single RFID card
is not possible.
To do this, proceed as follows:
1) Remove the housing cover and connection panel cover to access the
service button (see
5.2.1 Preparing the charging station
).
2) Hold the service button
1
pressed in the connection panel until the sec-
ond signal tone sounds (approx. 10 seconds).
The charging station will now automatically perform a restart, deleting all
previously taught-in cards in the process.
If the deletion was successful, the LED bar flashes green and charging with-
out authorization is possible.
