KEB COMBIVERT F5, Installation Manualline

Page: 16 / 32

16
3.5 Control Board Compact/General
3.5.1 X2A Control Terminal Strip
• Tightening torque 0,22...0,25 Nm (2 lb inches)
• Use shielded/drilled cables
• Lay shield on one side of the inverter onto earth potential
Installation and Connection
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29
PIN Function
Nam e Description
1
+ Set value input AN1+ Differential voltage inputs 0...±10 VDC; Ri = 55kOhm
2
- Set value input AN1- AN1: Setting of the analog set value
3
+ Analog input AN2+ AN2: no function at KEB factory settings
4
- Analog input AN2-
Progr. analog outputs 0...±10 VDC / max. 5 mA; defined by the manufacturer
5
Analog output 1 AO1 Output of the actual output frequency 0...±100 Hz
6
Analog output 2 AO2 Output of the apparent current 0...2 x I
N
7
+ 10 V Output CRF Reference voltage for set value poti (max. 4 mA)
8
Analog Mass COM Mass for analog in- and outputs
9
Analog Mass COM Mass for analog in- and outputs
Prog. Digital inputs Function of the inputs is defined by the manuf acturer
10 Fixed frequency 1 (CP.19) I1 13...30 VDC ±0% smoothed; Ri: 2,1 kOhm; scan time 1 ms
11
Fixed frequency 2 (CP.20) I2 I1 + I2 = Fixed frequency 3 (CP.21)
12
External fault I3 Input for external fault setting (E.EF)
13
DC-braking I4 Activates the DC-braking (CP.22/23)
14
Forw ard F Preset rotation;
15
Reverse R Forw ard has priority
16
Control release/ Reset ST Pow er modules are enabled; reset at opening
17
Reset RST Reset; only w hen an error occurs
Digital outputs max. 50 mA; function is defined by the manufacturer
18
Transistor output 1 O1 sw itched at factual = fset
19
Transistor output 2 O2 Ready signal (sw itched as long as no error occurs)
20
24 V-Output U
out
Supply of the programmable inputs
21
20...30 V-Input U
in
Voltage input for external supply
22
Digital Mass 0V Potential for digital in- /outputs
23
Digital Mass 0V Potential for digital in- /outputs
24
Relay 1 / NO contact RLA Programmable relay output (CP.31)
25
Relay 1 / NC contact RLB Load ability max. 30 VDC / 0.01...1A
26 Relay 1 / sw itching contact RLC Factory setting: Fault relay
27
Relay 2 / NO contact FLA Programmable relay output (CP.32)
28
Relay 2 / NC contact FLB Load ability max. 30 VDC / 0.01...1A
29
Relay 2 / sw itching contact FLC Factory setting: Frequency dependent sw itch