KEB COMBIVERT F5, Instructions For Use Manual, Page: 36 / 40

36
DSP402-Parameter
Name: DSP402_Controlword
Index:
6040h
Subindex: 0
Meaning: Control word with coding according to [4] . The parameter is bit-coded.
Data length: 2 byte
Coding: Bit-coded according to [4] . The following table only lists the bits that are realised in this soft-
ware. Note that some bits are different assigned by the settings of the DSP402-mode (see table
below):
Modes of
operation
b7 b6 b5 b4 b3 b2 b1 b0
Fault
Reset
Mode-dependent Enable
Operation
Quick
Stop
Ennable
Voltage
Switch
ON
255 „“ Res. Res. Res. „“ „“ „“ „“
2 „“ RFG
Use Ref
RFG
Unlock
RFG
Enable
„“ „“ „“ „“
Default value:
PDO-mapping:
receive PDO transmit PDO
YES YES
Note: This parameter is internally mapped to parameter
Sy.50
.
Name: DSP402_Statusword
Index: 6041h
Subindex: 0
Meaning: Status word with coding according to
[4]
. The parameter is bit-coded.
Data length: 2 byte
Coding:
Mode b15... b14 b13 b12 b11 b10 b9 b8... b7
Mode-dependent Int. Limit
Active
Target
Reached
Remote
255 Res. Res. „“ „“ „“ „“
2 Res. Res. „“ „“ „“ „“
b6 b5 b4 b3 b2 b1 B0
Switch ON
Disabl.
Quick Stop Volt. Enabl. Fault Operation
Enabl.
Switched ON Ready To
Switch ON
„“ „“ „“ „“ „“ „“ „“
„“ „“ „“ „“ „“ „“ „“
Default value:
PDO-mapping:
receive PDO Transmit PDO
NO YES
Note: This parameter is internally mapped to parameter Sy.51 .