|
keatingofchicago.com
PREVENTIVE MAINTENANCE
Preventive maintenance should be done in daily, week-
ly, monthly and yearly intervals as necessary. Following
preventive maintenance procedures will help keep your
Teppanyaki Griddle working effi ciently. Proper care and
servicing will lead to years of quality performance.
PREVENTATIVE MAINTENANCE CHART
TIME FRAME
OPERATOR/OWNER
AT LEAST
DAILY*
• Check lights and controls.
• Clean griddle surface.
• Drain and clean grease drawer.
• Completely wipe down griddle
cabinet.
AT LEAST
MONTHLY*
• Check condition of Teppanyaki
surface and review proper
cooking procedures.
• Check calibration of
thermostat(s).
• Review operating instructions
received with Teppanyaki griddle.
TIME FRAME
QUALIFIED SERVICE PERSONNEL
AT LEAST
YEARLY*
• Have Teppanyaki Griddle
completely checked, calibrated,
tested, cleaned, etc. by qualifi ed
service personnel.
*
High production facilities should be checked more often.
Contact the factory or a local service company to perform
maintenance and repairs.
Damage done to the Miraclean® surface is irreparable
and is not covered under Keating Warranty.
CALIBRATION
You will need:
One standard fl at blade screwdriver
One accurate griddle thermometer
1. Set thermostat to 300°F.
2. Allow thermostat to cycle three times.
3. Locate inverted “V” on front of griddle plate above
thermostat to be calibrated to locate thermostat bulb
position. Place thermometer on plate over bulb half
way toward rear of griddle.
4. If calibration of griddle is found to be less than
15°F off, remove knob. Loosen two screws in the
thermostat dial.
5. Replace knob. Turn dial plate until temperature
matches thermometer.
6. Remove knob. Tighten screws on dial plate.
Replace knob.
For calibration over 15° difference, contact your local
service distributor.
NOTE:
Calibration is not covered under warranty.
CLEANING -
Proper care should be taken to fully clean the griddle
on a regular basis.
DISCONNECT ELECTRIC POWER SOURCE BEFORE
CLEANING.
CONTROL PANEL - Clean any grease build-up on the
switches and thermostat knobs.
NOTE:
If grease gets into the body of the switch or
thermostat, it may cause it to fail.
IF GREASE GETS INTO THE BODY OF THE SWITCH
OR THERMOSTAT, IT MAY CAUSE ELECTRICAL
SHOCK.
See page
5 “CLEANING THE TEPPANYAKI GRIDDLE”
6
Summary of Contents for Teppanyaki Griddle
Page 12: ......