Keating Of Chicago Cooktop, Service Manual

Page: 7 / 16

4
Proper care should be taken to fully clean the Top-
Side
TM Cooker on a regular basis. The control panel
should be cleaned of any greasy residue with a damp
cotton cloth. Remove any residue from the ON/OFF
switch and the thermostat knob. Wipe down the
cabinet, sides and back on a regular basis.
INSTALLING A
COOKING SHEET
1. Raise Top-Side TM Cooking head completely.
2. Lay the 20'' x 24'' (508mm x 610mm) cooking sheet
on the griddle plate with 20'' (508mm) dimension
front to back.
3. Lower the Top-Side TM Cooker head onto the
cooking sheet, ensuring that the sheet is centered
under the head, the front edge of the sheet is even
with the front edge of the head, and the sides of the
sheet are parallel to the side of the head.
4. Fold both edges of the cooking sheet over the
head. While gently pulling the right side of the
sheet to remove any slack, firmly push the cooking
sheet mounting clip onto the right side mounting rib
on top of the head.
5. Repeat process on the left side.
6. Reverse the process to remove the cooking sheet.
TIPS ON PROPER
HANDLING AND USE
OF COOKING SHEETS
To ensure long life of your Keating cooking sheets
please follow the tips below:
Cooking sheets should never:
Be folded or creased.
Be touched with sharp objects.
Come in contact with griddle scrapers or abrasive pads.
Be placed under other equipment or objects.
Cooking sheets should always:
Be wiped with a damp soft cotton cloth after each run
to remove any product residue.
Be cleaned after the griddle is shut down for the day.
The time to change a Cooking Sheet is when:
Product starts sticking to the sheet.
Too much carbon build-up causes a product
appearance, cooking or taste problem.
The head surface is cool.
If the sheet is torn or ripped.
WARNING
THE TOP-SIDE TM COOKING HEAD AND GRIDDLE
PLATE ARE HOT - USE PROPER CARE WHEN
CHANGING THE COOKING SHEETS.
LEVELING OF
COOKING HEAD(S)
The cooking head(s) were leveled at the factory.
NOTE: For best results, level griddle before checking.
Adjust legs to level griddle.
REMOVING OF
COOKING HEAD
NOTE: To identify parts, refer to Figure 6-1 on page 6.
1. Turn off griddle and disconnect Top-Side™ Cooker
electric power.
2. Remove the cooking sheet by lifting off cooking
sheet mounting clips.
3. Place a layer of soft cloth and then a layer of
cardboard onto griddle plate under cooking head to
protect MIRACLEAN® surface.
4. Raise cooking head completely to release tension
on cooking head support pin. Remove support pin
and its cotter pin and carefully lower cooking head
to protected griddle surface.
WARNING
The cooking head is not supported after the
cooking head support pin has been removed. If
dropped the weight of the cooking head when
unsupported will cause damage to the griddle
surface or injury to personnel.
SECTION OPERATOR/OWNER
PREVENTIVE MAINTENANCE CHART
*High production facilities should be checked more often.
TIME
FRAME
Daily
Weekly
Monthly*
Yearly*
Clean all cooking sheets.
Clean all MIRACLEAN®.
cooking surfaces.
Clean all surfaces of
Top-Side TM Cooker.
Verify thermostat settings
Review cooking procedures.
Check Cooking Sheets (replace
if necessary).
QUALIFIED SERVICE
PERSONNEL ONLY
Thoroughly check and test
Top-Side TM Cooker.
Calibrate controls.
III
III
IV & V
III
IV & V