- 6 -
CONNECTING PARKING BRAKE LINE TO PARKING BRAKE SYSTEM BUILT IN CAR
NOTE:
1. After connecting the parking line, the video on the monitor of the front panel will be displayed only when
the hand brake is on.
2. Use the clip end of a ground line provided by manufacturer to connect the fixing screw bolt, use another
end of the Ground line to connect the negative pole of the power source. Otherwise, the video on screen
maybe flashing.
DESCRIPTION OF ISO FIXED FEMALE CONNECTOR
1.6
UNIT INSTALLATION
INSTALLATION INSTRUCTIONS
This is an anti-theft installation. The chassis wear a metal Sliding housing. Please have the wiring
connection of the Power supply, speakers and antenna as for the requirement Of the manual, then install
the metal sliding housing into the Car according to the diagram.
PARKING BRAKE
PARKING BRAKE SWITCH
(INSIDE THE CAR)
TO METALIC BODY OR CHASSIS OF THE CAR
PARKING BRAKE LINE (GREEN)
CONNECTOR A
1.
2.
3.
4. 12V
5. AUTO ANTENNA
6.
7. 12V (TO IGNITION KEY)
8. GROUND
CONNECTOR B
1. REAR RIGHT SPEAKER (+)
2. REAR RIGHT SPEAKER (-)
3. FRONT RIGHT SPEAKER (+)
4. FRONT RIGHT SPEAKER (-)
5. FRONT LEFT SPEAKER (+)
6. FRONT LEFT SPEAKER (-)
7. REAR LEFT SPEAKER (+)
8. REAR LEFT SPEAKER (-)
METAL STRAP
DASH BOARD
SLIDING METAL HOUSING
TO DRAW THE CHASSIS OUT OF THE
SLIDING METAL HOUSING, INSERT
THE LEFT AND RIGHT KEY PLATES
INTO THE TWO SIDES OF CHASSIS.
FRONT PANEL
PLASTIC TRIM OUT
UNIT CHASSIS
SELECT THE PROPER TABS
OF THE SLIDING METAL
HOUSING TO FIX THE
SLIDING METAL HOUSING.
TO REDUCE SKIPPING, PLEASE
FIX THE METAL STRAP ON THE
METAL CONNECTED TO THE
CHASSIS OF THE CAR.
