10
It is recommended to user, to install an OFF/ON switch on the wall for the Ceiling Fan, replacing existing regulator or new
regulator point. If your Remote Control missing or misplaced, the Ceiling Fan can be switched on at pre-set speed 2.
建議用戶將吊扇的 OFF/ON 開關安裝在牆壁上,替換現有的調節器或新的調節點。若您的遙控器不見了,吊扇可以以預設速
度 2 開啟。
ATTENTION /
留意
CAUTION /
注意
This product is not provided with cord and plug or with other means for disconnection from the supply. When
connect or change the power cord or lead wire, it must be replaced by the qualifi ed personnel in order to avoid
hazard. Please use 227IEC53(RVV) or thickness of tube is 1mm or above. (Other requirements such as diameter
of lead wire, please use according to the regulation of the country).
此產品沒有提供電纜和插頭或其他用作接駁電源的附件。當連接或替換電纜或電線時,這項工作必須交由能勝任的
人員執行以防危險。請使用
227IEC53(RVV)
或厚度超過1毫米的導管。(其他要求,例如電線直徑等等,請遵守相
關國家的條例)。
This product should be installed with a double poles single throw switch (Breaker Switch) with minimum 3mm
contact gap in the fi xed installation circuit.
Do not connect this Ceiling Fan to dimmer switch or regulator. (It can damage the Ceiling Fan)
此產品必須在固定安裝電路上裝上觸點間隙為最少 3 毫米的雙極單投開關(斷路開關)。
切勿將此吊扇連接至調光開關或調節器。(這會損壞吊扇)
Regulator /
調節器
Dimmer Switch /
調光開關
Should there be a dimmer switch or regulator, disconnect it and reconnect the wiring as below.
若有調光開關或調節器,請按照下圖拆除然後重新連接。
Power Supply /
電源
Connect Directly /
直接連接
Power Supply /
電源
Connect Directly /
直接連接
Regulator /
調節器
Dimmer Switch /
調光開關
WIRING DIAGRAM /
電線圖
CONNECTING THE POWER SUPPLY /
連接電源
Only direct connection to wall switch is allowed. Please refer to fi gure below.
只可以直接連接至牆壁開關。請參考下圖。
Ceiling Fan /
吊扇
Wall Switch (OFF / ON)
/ 牆壁開關 (
OFF / ON
)
Double pole single throw switch (Breaker Switch) /
Earth /
地線
230V~ / 50Hz
Power Supply
雙極單投開關(斷路開關)
230~
伏特直流
/ 50
赫茲
電源
~
Motor
Thermal Fuse
White
MAIN PCB
Red
Black
Blue
CN2
CN1
Brown Switch
N (Blue /
藍色
)
L (Brown /
棕色
)
E (Green / Yellow)
發動機
紅色
黑色
白色
熱熔絲
(
綠色 / 黃色
)
棕色
開關
Brown
棕色
藍色
主要印刷電路板
M11SU(REVISION)_EN-CT.indd 10
M11SU(REVISION)_EN-CT.indd 10
12/14/2010 12:40:07 PM
12/14/2010 12:40:07 PM