100.210 - Multi Water Sampler - 12 x 50 ml - Manual
4
6
Pos. 6 is now loaded and secured correctly; pos. 5 is
still in unloaded position.
Programming
7
Connect the 5-conductor cable from the motor to the
battery cylinder.
Charge the battery inserting the 8-conductor cable to
the Battery Charger connector. A fully discharged
battery requires charging for 8-10 hours, approx. The
charger contains advanced electronics preventing
overcharging even if connected for a long time.
The Subconn connectors requires to be greased with
Molykote, see recommendations on page 7-10.
The photo shows the programming plug (to the left)
and a dummy for the Subconn connector (optional).
8
The tablet comes with pre-installed software for the
programming. Once charged replace the charger cable
with the USB cable and connect to USB on the tablet.
9
Run the KC program on the tablet’s desktop
.
10
The software detects the hardware and the label “PLC
Connected” (located at the screens lower, left corner)
turns green.
