KBL megaSun 5800, Operating Instructions Manual

Page: 43 / 60

O p e r a t i n g I n s t r u c t i o n s |
KBL 5800
43
Tubes, fa cial and shoulder
tanners
DISMANTLING
Proceed as follows in order to be able to clean or
replace tubes, facial tanners or shoulder tanners:
Procedure Fig.
1
Dismantle the canopy, bed and side
panes.
40.1
40.2
40.3
2
Remove the tube covers in the facial and
foot areas.
3
For units equipped with tanning
lamps, you must also remove the
fi lter panes if you wish to replace the
lamps.
41.1
41.2
4
Remove the covers of the shoulder
tanner.
44.1
CLEANING CYCLE
In order to preserve the tanning effect, we recommend
cleaning the tubes and UV lamps with warm water
and a chamois after approx. 200 hours of operation.
Do not use any cleaning agents that are aggressive or
contain alcohol.
REPLACEMENT CYCLE
Only replace tubes, facial tanners, shoulder tanners
and starters with ones of the same type. When
installing the tubes, make sure that the inscription
is visible. In this position, the refl ector of the tube
is at the back. If your tanning unit is equipped with
CPI, you must carry out a reset after each tube
replacement. As far as inductive units are concerned,
also replace the starters with each tube replacement.
Reset the operating hours counter of the tubes after
each replacement.
Replacing the sunlamps of the
shoulder tanner
REPLACING THE SUNLAMPS
The sunlamps must be replaced after 600 hours of
operation. Let the unit cool down before replacing the
sunlamps. The tanning lamps must only be removed
and installed by trained and qualifi ed staff. The bed
pane must remain folded down during dismantling and
replacement.
Important: Do not operate the shoulder tanner without
sunlamp unit.
Procedure Fig.
1
Undo the screw of the outer covering
and lift off the outer covering upward
and toward the front.
44.1
2
Undo the screws of the chromium-plated
covering and pull off the covering toward
the front.
44.2
3
Disconnect the refl ector from the
electrical power supply by unplugging
the connector from the ignition device
at the place marked in the picture. Take
out the refl ector by pressing it downward
vertically and by turning it to the left while
keeping it pressed. Make sure not to jam
the socket.
44.3
44.4
4
Press one side of the clamp down in
order to spread it apart, and then remove
the sunlamp by holding the socket at the
opposite side and by pulling in a diagonally
upward movement. The light bulb and its
base represent one single component.
44.5