Unit lighting
COLOURED FILTER
The coloured fi lter has to be replaced at the latest when
replacing the tanning tubes.
REPLACING THE LIGHTING SYSTEM IN THE
CANOPY
Both in the canopy and in the lateral section, there is
a coloured lighting tube installed behind the tanning
tubes. (see Table).
Procedure
Fig.
1
Canopy: Open the canopy pane and tilt
it downwards.
40.1
40.2
2
Remove the tanning tubes 5 and 6. Now
you can replace the tube.
3
Re-install the tanning tubes and close the
canopy.
4
Lateral pane: Open the lateral pane and
remove the two upper tanning tubes. Now
you can replace the tube.
5
Re-install the tanning tubes and close the
lateral pane.
REPLACING THE UNIT LIGHTING IN THE LOWER FRONT
SECTION
The tube in the lower front section is located in a pro-
tective conduit, which has been screwed onto the tube
sockets. Take the opportunity to check the filter mat
and to clean or replace it if necessary..
Procedure
Fig.
1
Undo the two screws of the base pane
and tilt the pane upwards.
2
Unscrew the protective conduit on both
sides and push it to the right (or to the
left). Now you can replace the tube.
3
Close the base pane.
Figure 46.1 Unit lighting in the lower front section and the starter for this
tube on the left side.
CANOPY LIGHTING
Below the canopy casing you will find two energy sa-
ving lamps and a dual ballast. To replace the lamps
touch it at the lamp socket.
Procedure
Fig.
1
Remove the chromi-
um-plated front cover.
2
Unscrew the next
cover (5 screws)).
3
Remove carefully the
lamp downwards.
4
If it is necessary you can
change the refl
ector
now.
5
Insert the new refl ector
and the new lamp.
Mount the covers.
O p e r a t i n g I n s t r u c t i o n s
|
megaSun 5600
46
