Functions C‘M‘A‘B‘
④ ⑤
Depending on the confi guration of your system, the
menu item
PIN II/CMAB
allows you to switch on or
off certain functions.
Invoke the
1.
PIN II
menu and enter the PIN.
Set the desired value by pressing the plus and
2.
minus buttons of the corresponding letter.
Save the settings by pressing START, press STOP
3.
to leave the menu.
C (Channel) is deactivated if only external channel
selection with exactly one channel is available as
audio system for the unit. The channel-selection
symbol is not displayed.
M (Music) is deactivated if there is no audio system
available. No symbols regarding the audio system
are displayed.
A (Air-conditioning unit) is not displayed if the tanning
system is not equipped with an air-conditioning
unit. No symbols regarding air-conditioning are
displayed.
B (Facial tanners) You can switch the facial tanners
on or off here.
Air-conditioning functions
④
The menu item
PIN II/ACS
includes three submenus
for the control of the air-conditioning system:
PRESETTING AIR-CONDITIONING UNIT (AIRCON)
Use the menu item
AIRCON
to specify if the air-
conditioning unit should start automatically at the
beginning of the tanning session (ON) or if it must be
activated manually by the studio customer (OFF).
Invoke the
1.
PIN II
menu and enter the PIN.
Press START to invoke the menu item
2.
ACS
.
Select
3.
AIRCON
by pressing 5 (plus button) or 0
(minus button).
Activate the function by pressing 4 (plus button)
4.
or deactivate it by pressing 9 (minus button).
Use the START button to save the settings and
5.
press STOP to exit the menu.
INCREASING THE FAN SPEED (OFFSET)
The menu item
OFFSET
is used to defi ne whether
the fan should operate at a higher speed. An OFFSET
of 00-99% can be set in steps of 10 %. This measure
may become necessary in the case of poor venting.
Note that such modifi cations must only be carried
out by service staff!
Invoke the
1.
PIN II
menu and enter the PIN.
Press START to invoke the menu item
2.
ACS
.
Select
3.
OFFSET
by pressing 5 (plus button) or 0
(minus button).
Press 4 (plus button) to increase the value or 9
4.
(minus button) to decrease the value.
Save the settings by pressing START and exit the
5.
menu by pressing the STOP button.
INCREASING THE FAN SPEED (A.START)
A.START
is used to specify the fan speed at the
beginning of the tanning session. Values between 20
and 99% can be set. The value can also be changed
manually during the tanning session.
Invoke the
1.
PIN II
menu and enter the PIN.
Press START to go to the menu item
2.
ACS
.
Select
3.
A.START
by pressing 5 (plus button) or 0
(minus button).
Press 4 (plus button) to increase the value or 9
4.
(minus button) to decrease the value.
Press the START button to save the settings and
5.
STOP to exit the menu.
Setting the operating hours of
the tubes
④
Go to the menu item
PIN II/CM
if you want to enter
the operating hours of the tubes.
Settings on service level II
O p e r a t i n g I n s t r u c t i o n s
|
megaSun 5600
35
