7
2 4 4 1 2 M a i n S t . S u i t e 1 0 5 , C a r s o n , C A 9 0 7 4 5
Press and hold for 3 seconds to start the cleaning cycle, the Clean LED
flashes slowly.
Press and hold for 3 seconds again to stop the cleaning cycle, the Clean
LED goes off.
Green LED illuminates when the unit is plugged into power.
Red LED flashes quickly when more water is needed.
Green LED illuminates once water is full.
Dispensing Ice
NOTE
The unit does not dispense ice while the Clean LED flashes.
Dispense Nuggets b
utton
The unit will stop dispensing automatically after 60 seconds elapse.
Place a cup under the ice dispense point.
Press and hold to dispense ice, release to stop.
Combination Buttons
It can be used when the unit can’t dispense ice because ice is jammed.
While you hold the Dispense Nuggets button, press and hold the Clean
button to reverse the ice auger.
First time use
NOTE
For the first time use flush the unit following instructions below.
For the first time use dispense several cups of ice and then discard
them.
1.
Filling the water reservoir for the first time use
Remove the reservoir door by simultaneously pulling the left and right
sides outwards.
Add clean potable water to MAX WATER FILL.
Replace the magnetically attached door.