23
KB Racking Inc., 1050 King St. W., Toronto, ON, M6K 0C7 | 1 (888) 661-3204 | [email protected] | www.kbracking.com
Installing PV Modules
NOTE:
Pull clamps must be loosened completely prior to modules being
placed on supports. Loosen pull clamps to the end of the bolt thread so
the pull clamp is not resting along support edges (see below).
1.
Begin at an array edge placing module along bottom support edges in
landscape orientation. Ensure module is flush with support edge
(image below).
NOTE:
The bottom support features 3 teeth used to pierce the anodized
layer of the module creating an electrical bond between the module and
racking system. Ensure the support edge is in contact with the module.
2
. Lower back half of module on top support ensuring module rests on
top support edge (image below).
______________________________________________________________________________________
Pull clamp loosened
Pull clamp loosened
Bottom support teeth (3)
Bottom support
edge (red)
Top support edge
(red)
Module
