Fig. 3.3
Fig. 3.4
Page 10
3. Remove the air filter.
4. Clean the air filter by vacuuming the surface or washing
in warm water with mild detergent.
A. If using a vacuum cleaner, the inlet side should face
the vacuum.
Repairing Refrigerant Leaks
WARNING
• If the refrigerant leaks, turn off the air conditioner and
any combustible heating devices, ventilate the room
and call your dealer immediately. Refrigerant is both
toxic and flammable. Do not use the air conditioner
until the leak is repaired.
• When the air conditioner is installed in a small room,
measures must be taken to prevent the refrigerant
concentration from exceeding the safety limit in the
event of refrigerant leakage. Concentrated refrigerant
causes a severe health and safety threat.
Refrigerant Leak Detection System
(some models)
In the event of a refrigerant leak, the LCD screen will display
"EC" and the LED indicator light will flash.
Preparation For Periods Of Non-Use
Maintenance after Extended Non-Use
1. Remove any obstacles blocking the vents of both the
indoor and outdoor units.
2. Clean the air filter and the front grille of the indoor unit.
Reinstall the clean, dry air filter in its original position.
3. Turn on the main power switch at least 12 hours prior
to operating the unit.
Storing the Unit While Not in Use
1. Run the appliance on FAN mode for 12 hours in a warm
room to dry it and prevent mold.
2. Turn off the appliance and unplug it.
3. Clean the air filter according to the instructions in the
previous section. Reinstall the clean, dry filter before
storing.
4. Remove the batteries from the remote control.
B. If using water, the inlet side should face down and
away from the water stream.
5. Rinse the filter with clean water and allow it to air-dry.
Do not
let the filter dry in direct sunlight.
6. Reinstall the filter.
