Kaysun KCT-03 SR, Installation And Owner'S Manual

Page: 15 / 32

12
Press (Swing) button to control the swing of the vertical louver of indoor unit (see Figure 6.8).
When the unit is on, the display icon shows the swing angle of the current louver.
Press (Swing) button, and the louver switches from the current angle to the angles in turn as shown in Figure 6.9.
Angle 1 Angle 2 Angle 3 Angle 4 Angle 5 Auto Stop
Figure 6.9
When the louver is in " Auto " state, Press (Swing) button again, and the louver will stop at the current operating
angle, and the display icon will show the current angle of the louver after 10 seconds.
Note:
• The swing function is only available for indoor units configured with vertical louver.
• When the unit is off, the (Swing) button is invalid, and the wired controller automatically turns off the swing
function, and the display icon will no longer show the swing angle.
• This wired controller is unable to control horizontal swing in indoor unit.
4-5 Function Setting
Angle 1 Angle 2 Angle 3 Angle 4 Angle 5 Auto Stop
Figure 6.10
Press (Function) button to switch to the function that can be set in the current mode (see Figure 6.10).
• Press (Function) button to go to the function setting, and the display on the wired controller will show in turns: " ",
" ", " ", " ", " " (reserved). Alternatively, you can press ▲ and ▼ buttons to switch to the selected function.
(see Figure 6.11)
→ → → →
Auxiliary
Heater
Start
Off
Steady on
Off
Blink
Figure 6.11
• Press (Function) button to go to the function settings. Press (Function) button each time to select the function,
and the icon for the selected function will blink. Press (Confirm) button to confirm the function, or (Cancel) button
to cancel the function.
4-5-1 IDU LED Display
The " IDU LED Display
" function is used to control the on/off state of display in the indoor unit.
→ → → →
Auxiliary
Heater
Start
Off
Steady on
Off
Blink
Figure 6.12
Press (Function) button to go to the function setting page. Press (Function) button again to select " ", and the IDU
LED Display icon " " will blink. Then press (Confirm) button to confirm, and " " will light up, or press (Cancel)
button to cancel, and the " IDU LED Display " function will turn off. (see Figure 6.12)