10
6) To release the contents, the
WHIPcreamer INOX
(image G) must be turned upside down and the
lever must be actuated. Always hold the
WHIP-
creamer INOX
vertically with the unit head facing
down. This ensures that no gas can escape,
enabling the complete emptying of the bottle.
7) Depending on the contents and application, store
the filled
WHIPcreamer INOX
between min. +1°C
to max. +70°C upright in the refrigerator or in a
bain-marie (image H).
8) Unscrew the decorating nozzle after each use and
rinse it with warm water.
9) After the contents have been completely removed,
actuate the lever of the
WHIPcreamer INOX
to
relieve the pressure until all of the gas has been
released (image I). Always hold the
WHIPcreamer
INOX
vertically with the unit head facing down.
Then the
Kayser
unit head can be easily unscrewed
from the
Kayser
bottle.
IMPORTANT INSTRUCTIONS FOR
USE
• The safety regulations specified on the charger
packaging apply to the
Kayser
cream chargers.
•
Kayser
cream chargers are made of recyclable
steel and are reclaimed as a valuable raw material
in the waste recycling.
• If the consistency of the bottle contents is
insufficiently firm, shake the bottle once again.
However, do not shake the
WHIPcreamer INOX
before each additional use. Shaking too often will
cause the contents to become too firm to remove
them completely.
• Some products, such as UHT cream or light cream
must be chilled thoroughly and shaken more often
in order to achieve a sufficiently firm consistency.
• Only store the
WHIPcreamer INOX
in a refrigerator
in order to chill its contents. Never use a deep
freezer or the freezing compartment.
• Never use the
WHIPcreamer INOX
for the heating
up of food. Keeping the filled
WHIPcreamer INOX
warm in a bain-marie is permissible up to a
maximum temperature of +70°C.
MAINTENANCE AND REPAIR
• When it is not possible to easily insert the unit
piston K513i in the head after cleaning during
the reassembly of the
Kayser
unit head, smooth
movement can be restored by lubricating the
piston gaskets with cooking oil.
• Please contact
Kayser
should other problems
arise.
• Check the condition of the head gasket (K750)
and of the two gaskets on the piston (K513i)
before each use – see page 2. When signs of wear
become visible or leakage occurs during use, then
these parts must be replaced. Before each use,
check the bottle, the unit head and the threads
for possible signs of wear or damage. If any such
wear or damage is found, the
WHIPcreamer INOX
may no longer be used.
