EN
43
7. Control panel
8. Bell
9. Bicycle basket
10. V-brake
11. Front lamp
12. Front wheel with hub motor
13. Front mudguard
14. Pedal
15. Crank section
16. Chain
17. Hub gear
18. Hub brake
19. Back mudguard
20. Back lamp
21. Battery, on/off
22. Carrier rack
23. Battery
FIG. 1
CONTROL PANEL
1. Power switch, on/off
2. Assistance 6 km/h
3. Button to select assistance level
4. Battery indicator
FIG. 2
BATTERY
1. Battery indicator
2. Battery, on/off
3. Key lock, battery
FIG. 3
ASSEMBLY
SADDLE
Open the quick-release for the saddle post and
put the saddle post in the hole in the frame.
Lock the saddle post at the required height with
the quick-release.
WARNING!
Do not put the saddle over the marking for the
max height on the saddle post. The marking
means that at least one third of the saddle
post must be inserted in the frame.
FIG. 4
FRONT WHEEL
Fit the front wheel by aligning the wheel’s centre
bolt in the bottom part of the front fork, making
sure that the wheel goes through the V-brake
all the way. Fasten the wheel’s centre bolts and
tighten. Connect the cord from the motor with
the cord on the front fork.
HANDLEBARS
Fit the handlebars in the recess on the column.
Put the clamp over the handlebars and tighten
the two screws.
WARNING!
Do not raise the handlebars over the marking
for maximum height.
PEDALS
Screw the pedals onto the pedal arms and make
sure to fit them the right way round. The pedal
are marked with R for right and L for left.
Summary of Contents for 005018
Page 4: ...1 2 1 2 3 9 12 11 10 23 22 8 7 21 6 5 4 20 19 18 17 16 15 14 13 1 4 3 2 6 KM H...
Page 5: ...3 4 2 3 1...
Page 6: ...5 6 7...
Page 7: ...11 8 9 10...
