Kayoba 002-714, Operating Instructions Manual, Page: 25 / 26

EN
25
3. Fasten the computer over the top end of the handlebar post
with the screws.
FIG. 7
USE
FUNCTIONS
Auto On/Off & Auto
The exercise computer is switched on all the time the equipment
is used. After 4 minutes of inactivity the exercise computer
switches off automatically.
Automatic scanning
Press the button until the arrow points to A. The exercise
computer switches between showing 5 functions: Speed,
Distance, Time, Odometer and Calories. Each value is shown for
6 seconds.
Speed
Press the button until the arrow points to S to show the actual speed.
Distance
Press the button until the arrow points to D to show the distance
you have cycled.
Time
Press the button until the arrow points to T to show how long you
have been exercising.
Total distance
Press the button until the arrow points to O to show the total
distance you have cycled on the exercise bike
Calories
Press the button until the arrow points to C to show consumption
of calories.
Pulse
Press the button until is shown to show your pulse. When
measuring your pulse place both palms against the sensor
surfaces on the handlebars. The pulse is shown on the display
after 4–5 seconds.
Reset
Press the button for more than 3 seconds to reset all the values
except for the odometer.
Saddle, saddle post and post cap
1. Put the post cap (31) over the frame tube.
2. Remove the nyloc nuts M8 and washers (33) from the saddle
(32).
3. Place the saddle over the saddle post and fasten the saddle
with washers and nyloc nuts.
4. Put the saddle post in the saddle post bushing on the frame
tube and fasten the saddle height adjustment knob (29) on
the frame tube by turning it clockwise to lock the saddle post
in the required position.
FIG. 4
Handlebar post, handlebar post cap
and load control
1. Remove 4 screws and 4 spring washers from the frame (1).
2. Push up the handlebar post cap (30) over the handlebar
post. Put the wire to set the load through the hole in the
handlebar post and pull it out through the square hole in
the handlebar post.
3. Connect the sensor cable from the frame to the sensor
extension cable from the handlebar post.
4. Fitting the handlebar post on the frame and secure with
4 screws and 4 spring washers.
5. Push down the handlebar post cap along the handlebar
post.
6. Remove the screw and spring washer from the load control.
7. Put the end of the wire on the load control in the spring
hook on the wire to set the load. Pull the wire on the load
control up and put it in the metal fastener on the wire to set
the load. Fasten the load control on the handlebar post with
the screw and spring washer.
FIG. 5
Handlebars
1. Remove the screws and spring washers from the handlebar
post.
2. Put the pulse sensor cables through the hole in the
handlebar post and pull them through the top end of the
handlebar post.
3. Fasten the handlebars on the handlebar post with screws
and spring washers.
FIG. 6
Computer
1. Undo the screws from the computer.
2. Connect the pulse sensor cables and the sensor extension
cable to the cables from computer. Put the cables in the
handlebar post.