ZHEJIANG KAYO MOTOR CO., LTD.
REBOUND
OF
THE
VEHICLE
INCLUDING THE DRIVER
MEASURE THE DISTANCE BETWEEN THE CENTER OF THE REAR WHEEL AND THE
REAR FENDER IN SUSPENSION
The measurement procedure is as below:
1. Place your motorcycle on its center stand stably.
2. Select a fixed point on the side of the rear fender and
mark it as "point 1".
3. Measure the distance from "Point 1" to the center of
the rear axle and record it as "A1".
4. Remove the motorcycle from the rack
MEASURE DISTANCE BETWEEN CENTER OF REAR WHEEL AND REAR FENDER
UNDER NO LOAD
The measurement procedure is as follows:
1.
The motorcycle is up right so that the center
surface of the tire is perpendicular to the ground
2.
Measure the distance from the center of the rear
wheel axle of the motorcycle to "point 1" and record it
as "A2".
3.
Use a single stand to support the vehicle
4.
Calculate the difference between "A1" and "A2"
and denote it as "D1".
The value of "D1" when 2021 TS90 motorcycle leaves
factory is shown below
D1
TS90
10
～
34mm
MEASURE DISTANCE BETWEEN REAR WHEEL CENTER AND REAR FENDER IN
DRIVING CONDITION
The measurement procedure is as follows:
1. The driver rides the motorcycle (the engine does not
start)
2. Up right the motorcycle so that the center surface of
the tire is perpendicular to the ground
3. Measure the distance from the center of the rear
wheel axle of the motorcycle to "point 1" and record it
as "A3".
4. The driver uses a single stand to support the vehicle
and leave the seat
Calculate the difference between "A1" and "A2" and
denote it as "D2".
The factory default value of "D2":
D2
TS90
40
～
100mm
If "D2" measured by the customer is lower than the
www.kayomoto.com
