2 0 H a M e s i l a S t . , N e s h e r 3 6 8 8 5 2 0 , I s r a e l
P O B 2 5 0 0 4 , H a i f a 3 1 2 5 0 0 1 , I s r a e l
T e l : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 0 0 F a x : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 1 1
Page no. 44 | CLI Interface
8
CLI Interface
8.1
JetCam Terminal control
A Mini USB port is available for individual link status, general information and firmware update. The port uses a
Silabs CP2101 chip. A driver from the Silabs website might have to be installed on certain PCs to gain access to
the terminal port. Free supporting driver can be found at:
http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx
After driver installation and USB connection is acquired a serial emulated terminal (i.e Tera Term use is
recommended) can be used with the following configurations, described in the table below:
Table 25 – Serial communication configuration
The terminal supports the following commands. Each command must be followed by carriage return (Enter) in
order to execute:
NOTE: The commands are not case sensitive.
Table 26 – Terminal commands
8.2
JetCam Firmware update
The JetCam Cameras supports firmware update via USB using a serial emulated terminal. To initiate a firmware
update follow the next steps:
1.
Download the latest firmware from KAYA's website.
NOTE: Please make sure to download the correct FW for the camera that you have, as installing an incorrect
FW may cause the camera to malfunction.
2.
Connect a USB cable between the computer and the camera and acquire connection using Silabs drivers
(drivers need to be downloaded manually if an automatic download is not initiated).
3.
Open serial emulated terminal (usage of Tera Term terminal is recommended) and set serial communication
protocol as described Table 25:
Parameter
Value
Baud rate
115200
Start bits
1
Stop bits
1
Parity
None
Flow Control
None
Command
Description
Firmware
Sets the system to firmware update mode. See 8.1 chapter for firmware update
information
Status
Prints the system and individual link status and general information
