2 0 H a M e s i l a S t . , N e s h e r 3 6 8 8 5 2 0 , I s r a e l
P O B 2 5 0 0 4 , H a i f a 3 1 2 5 0 0 1 , I s r a e l
T e l : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 0 0 F a x : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 1 1
Page no. 7 | Mechanical Properties
5
Mechanical Properties
This section provides information on JetCam camera unit hardware. It covers architecture, interfaces and pin
assignments for various connectors.
NC GND
Power Connector
SDI Connector
Serial Connector
12V
Link Status LEDs
System status LED
GPIO Connector
QSFP Connector
Figure 1 – JetCam camera interfaces
5.1
Link Status LEDs
The QSFP+/SFP+ bi-color LEDs are located below the QSFP+/SFP+ connectors. Color-coded indication along with
exact timing for each indicator are described in the following tables:
LED state
Indication
Off
Camera is not powered
Solid orange
Camera is booting
Solid red
Camera is powered but no active connection
Fast flash alternate green / orange
Fast flash alternate green / orange - Connection detection in progress
Solid green
Camera is connected, no data being transferred
Fast flash green
Camera is connected, data is being transferred
Slow pulse orange
Camera is connected. Waiting for trigger event
Table 2 – Link connector indicating lamp states
Indication
Timing
Fast flash
12.5Hz (20ms on, 60ms off)
Slow flash
0.5Hz (1s on, 1s off)
Slow pulse
1Hz (200ms on, 800ms off)
Table 3 – Connector indicating lamp timings
