kawneer.com
Laws and building and safety codes gover
ning the design and use of glazed
entrance, window
, and curtain wall pr
oducts vary widely
. Kawneer does not contr
ol
the selection of pr
oduct configurations, operating har
dwar
e, or glazing materials,
and assumes no r
esponsibility ther
efor
.
Kawneer r
eserves the right to change configuration without prior notice when deemed
necessary for pr
oduct impr
ovement.
© Kawneer Company
, Inc., 2011
EC 97904-36
2
1"
7/16"
#8-32 x 1-15/16" FHMS
FEBRUARY, 2011
KAWNEER 1686 CONCEALED EXIT DEVICE
INSTALLATION INSTRUCTIONS (PART NUMBER 038-310)
CYLINDER PAD ASSEMBLY:
1) Insert a 15/16" cylinder into the mounting pad and secure with the retaining ring.
Note: If using a cylinder longer than 15/16", cylinder
rings will be required to maintain the 7/16" projection.
Cylinder
Mounting Pad
15/16" Cylinder
with 0.800" cam
Retainer
Ring
CYLINDER INSTALLATION:
1) On exterior side of door, install the cylinder assembly into cutout on the door stile.
2) On interior side of door, install (2) #8-32 x 1-15/16" FHMS through door stile to secure cylinder assembly in position.
DEVICE ATTACHMENT:
1) Undog exit device before attaching to door.
2) Attach exit device onto pivot stile and lock stile of door with fasteners provided, as indicated below.
3) Install cover brackets (on top & bottom of device) onto exit device with fasteners provided.
Pivot Stile Fastener
1/4-20 x 1/2" PHMS
End Cap Bracket
TO DOG EXIT DEVICE
Insert the hex key and turn clockwise until it stops.
Fully depress touch bar and release the key.
With touch bar retracted remove hex key.
TO UNDOG EXIT DEVICE
Push on touch bar. Insert hex key and turn clockwise
until it stops. Release touch bar, when the touch
bar is in the extended position release hex key and remove.
PUSH PAD DOGGING:
Lock Stile Fastener
#12-24 x 1-1/4" PHMS
Lock Stile Fastener
#8-32 x 1-1/4" Cap Screw
Insert cylinder assembly
into cutout.
Install
Cover Bracket
and Fastener
