KAWMET P2, Installation And Operating Instructions Manual

Page: 16 / 52

16
• Do not remove the burning chamber.
• Do not burn in the fireplace of waste plastic, rubber, rubber products and other fatty
foods that cause air pollution and increase the risk of fire in the chimney.
• Do not burn when ashtray is completely open, because then the furnace reaches too
high temperatures that can cause deformation of the cast or their rupture.
• Do not pour water furnace to put out the fire.
• Do not completely fill the niche on the wood, so as not to block the air flow into the
heating chamber of fireplace.
• Do not place flammable items there such as paper, boxes of matches, etc.
3. Description of the device
Cast iron freestanding stove
Cast iron stove segments are composed in whole, sealed with sealant and bolted. P2 is
additionally lined with refractory bricks. The furnace door is sealed with heat-resistant glass.
At the bottom of the burning chamber is cast iron grate. Under the grate was built on tin,
pop ash pan. Ejecting the ash is after opening the iron door. The front frame of the furnace is
equipped with a damper for the primary air inlet. The damper can be moved in two extreme
positions and is used to control the amount of air fed into the burning chamber grate. P2
furnace is equipped with a control in the exhaust channel through the use of damper.
Model
Heating
Power
(kW)
Dimensions
(mm)
(height/width/depth)
Glass dimensions
(mm)
(height/width/depth)
Weight
(kg)
Flue gases
outlet
(mm)
P2 10 600/650/490 239/425/4 185 180
P3 6 630/460/390 196/268/4 90 150
P10 10 620/490/420 230/270/4 77 150
Cast iron fireplace insert
Cast iron fireplace insert segments are composed in whole, sealed with sealant and bolted.
At the bottom of the burning chamber is cast iron grate. Under the grate was built on tin,
pop ash pan. The front part of the ash is equipped with a primary air damper to the
combustion process. The damper can be moved in two extreme positions and is used to
control the amount of primary air fed into the burning chamber grate. A fireplace insert is
equipped in the regulation in the flue through the use of damper lever adjustable in position
to an existing chimney draft. Operation of the fireplace is by mounting it with non-
combustible construction, so that the visible part of the contribution of the anterior wall of
the door with heat-resistant glass. When the door-loads of fuel as well as the observation of
the flame.
Fireplace, excluding the contribution of W9, W9A and L12, can function in a continuous
combustion system.
Fireplace with water jacket
The rear, side and upper walls of the burning chamber of is water jacket with a wall
thickness of 25-30 mm. In upper part of water jacked are located special pipes. The purpose