Kawai CA901, Owner'S Manual

Page: 107 / 110

Appendix
Assembly
Instructions
Pass the pedal connection cable coming out of
the pedal board (E) through the aperture of the
back board (D) to the back of the instrument, and
connect it to the PEDAL terminal on the bottom of
the main body (A).
Connect the power cable into the [AC INLET]
terminal.
Use the binders on the side boards (B and C) to
ê x the cables in place.
5. Connecting the cables
When inserting the plug at the end of the
pedal cable into the jack on the bottom of
the main body of the digital piano, be sure
to align the pins with the position of the
hole in the jack, and then insert the plug
straight into the jack as far as it will go. If
the plug is forcibly inserted in the
improper alignment, the pins may bend or
break.
CAUTION
Attach the headphone hook to the underside of
the main body using the two installation screws
provided as shown in the illustration below.
Be sure to turn the pedal support bolt on the back
of the pedal base (E) anti-clockwise to extend the
bolt until it makes contact with the
ë oor and
supports the pedals ê rmly. Depending on the
material and condition of the ë oor,rr there may a
noise caused by friction with the ë oor when the
pedal is depressed. If this happens, place felt or
carpet between the pedal support bolt and the
ë oor.rr
6. Attaching the headphone hook
7. Adjusting the pedal support bolt
If the instrument is used with the pedal
support bolt
ë oating o é the ë oor or
pressed strongly against the ë oor,rr the
pedal board may be damaged. When
moving the instrument, lift
ff the instrument
o é the ë oor and do not drag it.
CAUTION
107