KaVo 1.007.0150, Instructions For Use Manual

Page: 19 / 28

Instructions for use INTRA LUX Motor KL 703 LED – 1.007.0150
6 Checking for malfunctions and troubleshooting | 6.2 Troubleshooting
19 / 28
6.2.1 Replacing the KaVo Mini LED lamp
CAUTION
Danger from hot lamp.
Risk of burn injury.
4 Do not touch lamp after previous operation. Allow the lamp to cool down.
4 Pull the sleeve off while twisting it slightly.
4
Push the old KaVo Mini LED lamp out of the mount with your fingernail and
remove it.
4
Insert the new KaVo Mini LED lamp into the recess such that the contact
surfaces align with those of the mount.
4
Slide the KaVo Mini LED lamp into the mount.
4 Place the sleeve on the motor and pull it up.
NOTE
The LED lamp is a semiconductor element and must be operated with direct
voltage only. The lamp must be inserted with the poles in the correct orienta-
tion for the lamp to work properly.
▪ Case 1: KaVo Mini LED lamp is on
▪ Case 2: The KaVo Mini LED lamp is faint
4 Increase the cold light intensity on the unit until the desired illuminance is
reached.
▪ Case 3: The KaVo Mini LED lamp is red or off
4 Insert the KaVo Mini LED lamp after rotating it 180° about its axis.
4
Put the sleeve on while twisting slightly.
6.2.2 Replacing the O-rings
CAUTION
Missing or damaged O-rings.
Malfunction and premature failure.
4 Make sure that all O-rings are on the coupling and are undamaged.
NOTE
Stop working if the O-ring is missing or damaged.
CAUTION
Improper care of the O-rings.
Malfunction or complete failure.
4 Do not use Vaseline or other grease or oil.
NOTE
The O-rings on the motor attachment may only be lubricated with a cotton
ball wetted with KaVo Spray.
NOTE
If the connection to the instrument is not leak-proof, replace all O-rings.
4
Press the O-ring between your fingers to form a loop.
4 Push the O-ring to the front, and remove it.
4 Insert new O-rings into the recesses and spray them with KaVo Spray.