Operating Manual
Original Operating Manual
13
Make the settings in the numerical sequence and in the direction of the arrows.
The pressure indication on the manometer gauge drops after clamping.
This is
not
a malfunction of the attachment, being caused by the installation of a
transmission
5.
Operation
5.1
General
At least once per working shift, the machine and equipment must be inspected for
visible damage and defects.
Repeat faults to your superior and have them rectified without delay.
Be aware of persons present in the area where you are working or driving and ensure
that they are not endangered.
Do not transport any load exceeding that specified on the residual load plate for the
particular combination of lift truck and attachment.
5.2
Load handling
Select the diameter range of the clamp by adjusting the short clamping arm at a 45°
angle to the rotator. Set the arms to the greatest possible width of the load.
Position the mast vertically and take up the load parallel to the floor.
Move the roll clamp to the load until the pressure plates and the centre of gravity of
the load are diagonal.
Position the mast vertically and take up the load parallel to the floor.
Raise the load about 300 mm and tilt the mast backwards.
Centre the load to the middle of the lift truck during take-up and transport.
