Kauo Heng KH-323 SERIES, Operation Manual

Page: 5 / 57

○
2
Fig.1.1 illustrates the correct position of jacking while moving the
machine. It is very important when moving the machine. The yarn
carrier rail shall never be used to push the machine since it will distort
the rail.
Fig.1.1Correct position of jacking the machine
○
3
When connecting the electric power, attention must be paid to the
correct voltage. And make sure the ground-wire connected.
2. Installation
○
1
After unpacking and locating the machine in the factory, it must be
leveled carefully with a spirit-level to avoid machine distortion in
running. We recommend the machine to be leveled with rubber peddings
for best result. Remove grease from the polished parts before starting to
operate the machine. About the moving parts must be lubricated
according to the following instruction.
Lubrication points Lubricant Frequency
Carriage
＃
10 oil Daily
Carrier rail
＃
10 oil Daily
Needle bed
＃
10 oil Daily
Driving parts Hi-temp grease Weekly
Table 2.1 Lubrication
○
2
Raise the yarn stand till the end of the tubes is leveled with the base plate,
tighten the screws and connect the plug of stop motion situated at the
left rear end.
1-2