KATflow 200
4 Operation
4.5.2 Diagnostic displays
Display screen
Operation
Line 1 shows the amplifier gain.
Line 2 displays the signal strength.
Line 3 indicates the noise.
Change to more diagnostic displays by
pressing
<NEXT>
.
Refer to Customer Support for the meanings of
each diagnostic screen
4.5.3 Totalisers
The totaliser displays will only be shown when the totalisers are activated.
Display screen
Operation
The flow totaliser can be started or reset by
pressing
<Q
ON
>
when a volume measurement
is selected as one of the displayed units.
Totalizer screens are viewed by pressing
<NEXT>
from the measurement screen. When
top and bottom display lines are set to a
volume measurement, the first totalizer screen
displays cumulative totals and the second
screen shows separate positive and negative
totals. Pressing
<NEXT>
again will return to
the main measurement screen.
Pressing
<Q
+
>
resets the total accumulated
flow in the positive flow direction.
Pressing
<Q->
resets the total accumulated
flow in the negative flow direction.
The totalisers can be stopped by pressing
<Q
OFF
>
.
Pressing
<Q
ON
>
again will reset to zero.
Change to other displays or revert to the total-
izer screen without resetting by pressing
<DISP>
or
<NEXT>
.
4.5.4 Datalogger
The datalogger is enabled from the Main Menu, and operates when a non-zero
value is entered for the interval.
Items to be logged are selected from the “Selection” screen. “ENTER” selects
items, “0” deselects. Up to ten items may be selected.
(Note : If no items are selected the logger will record blank space)
Send logger by serial port to a terminal program by selecting “Log download”.
Clear the logger by selecting “Log Erase”.
Remaining logger space can be seen in the Diagnostic displays.
Logged data can be downloaded, viewed and exported using the soft-
ware except when "wrap" mode has been enabled.
25
☞
