Kathrein UFS 903 sw, Operating Manual

Page: 26 / 124

26
Connection and setup
Confi gure satellites
Press the button to call up the menu. Use the buttons and the button to select which
satellites (max. 64) you would like to receive with your reception system. The following display appears
(example):
To deactivate a satellite, use the
buttons to select it and then press
the button.
Use the buttons to select the fi rst satellite slot. Press the button to open the menu for the
satellite settings. The following display appears (example):
Satellite
Use the buttons to adjust the desired satellites for the position you have selected.
However you can select here only those satellites that you had previously identifi ed (checked).
Test transponder
Use the buttons to select a transponder for the satellite selected above.
LNB Type (settings)
Press the button and use the buttons to select the LNB type used in your system. The
selections available are “Universal” and “user-defi ned” (the selection “Wideband” is required only for
single-cable feed systems).
Universal:
No further input is required, since all necessary frequency ranges are covered by a universal LNB.
user-defi ned:
If you choose not to use a universal LNB, you must here set the frequency ranges for which your LNB
was confi gured.