16 of 28
Operating the App
8.2
Programming a Single-cable Outlet Using the App
✔
The
Kathrein ESU
app and the SWP 50 programmer are connected.
✔
Connect the programmer to a compatible single-cable outlet.
8.2.1 Operating Instructions
●
The user bands are displayed as numbered buttons (
①
in the figure on
the left).
●
The configuration is shown using the following symbols:
– a user band is unblocked
– a user band is blocked
– a change has been made but has not been sent to the outlet yet
– send changes to the outlet
●
As supplied to customer, single-cable outlets of the ESU 50 series can
be configured without any restrictions (Lock against change is turned off);
see
Lock Against Change, p. 19
.
●
If the Lock against change is on, configuration of a single-cable outlet of
the ESU 50 series can only be performed by an authorised person; see
Lock Against Change, p. 19
.
1
●
16 user bands are shown in the user interface at the same time.
►
Swipe over the numbered buttons to change between user bands 1 – 16 and 17 – 32, see figure
below.