Kathrein ARU4 Series, User Manual

Page: 98 / 122

98 of 122
Operating the Reader Using the ReaderStart Software
14.8.3 Change Reader Parameter
Change reader parameter allows to change all reader settings using their respective configuration IDs.
4
6
1
2
4 5
3
Fig. 59: Expert settings 2: change reader parameter
཰
Parameter ID selects the parameter ID
ཱ
Parameter value
shows or sets the parameter value
The value is either decimal or hexadecimal, it is possible to switch between dec and hex .
ི
Active parameter
set
shows the current active parameter set
ཱི
Get reads the value of the current parameter set of the reader and shows it at
ཱ
ུ
Set writes the parameter value (
ཱ
) into the selected parameter ID (
཰
)
14.8.4 Select Filter Settings
By means of these settings, it is possible to filter certain tags, e.g. to only read tags with the defined data in the respec-
tive memory banks. It is possible to set up to 32 filters.
7
8
9
10
11 12
2
4 5
1
2
3
4
5 6
Fig. 60: Expert settings 2: select filter settings
཰
Filter selects a filter
ཱ
Target
selects the tag target session
Ź
Make sure the target matches the session set in
ྂ
Fig. 57, p. 97 .
ི
Action
selects the action; see also EPCglobal Gen 2 Specification (p. 73)
Tip
Ź
To see the description of an action, hover over the Action field.
ᇜ
The description of the action appears in the tooltip:
ཱི
Memory bank selects the memory bank ( RFU / EPC / TID / User )
ུ
Save select filter
data to file
saves the select filter data to file
ཱུ
Load select filter
data to file
loads the select filter data from file
ྲྀ
On activates or deactivates the select filter
ཷ
Bit pointer
sets from which memory address the filter compares the mask data
ླྀ
Mask length sets the mask length (0–255)