3 / 8
►
The equipment described is designed solely for the installation of satellite
receiver systems.
►
Any other use, or failure to comply with these instructions, will result in
voiding of warranty cover.
►
Install the device in dry indoor areas only. Do not install on or against
highly combustible materials.
►
Make sure that the devices are equipped with an equipotential bonding
conductor (Cu, at least 4 mm2).
►
Make sure to comply with the safety regulations set out in the current
EN 60728-11 and EN 62368-1 standards.
►
Fixings: Screws, max. Ø: 4 mm
►
Connectors: RF connector 75 Ω (F series) to EN 61169-24.
►
Terminate any unused RF ports with 75-Ω resistors, e.g. EMK 03.
►
To meet EMC requirements, the only power supply unit allower to be used
is the NCF 18.
Danger of property damage!
If the inner cable conductor diameter is more than 1.2 mm, or if burring is
present, the device sockets may be destroyed.
Max. 2 mm
excess length
Clamping torque
max. 3.4 Nm
(danger of over-
winding)
Diameter
0.6 - 1.2 mm free of burrs
Installation Instructions
