CORDLESS LINE TRIMMER INSTRUCTION MANUAL
250MM/10” OR
300MM/12”
CUTTING SWATCH
SELECTION
1. PULL
2. ROATAE
0.
250MM/10” OR
300MM/12”
CUTTING SWATCH
SELECTION
1. PULL
2. ROATAE
0.
5
LINE TRIMMER BASICS
HOW TO ADJUST LINE LENGTH
HOW TO REFILL TRIMMING LINE
HOW TO ADJUST SHAFT ROTATION
1
2
3
250MM/10” OR
300MM/12”
CUTTING SWATCH
SELECTION
1. PULL
2. ROATAE
0.
1
2
2
1. Pull the top half of the shaft adjustment
collar (4) towards the adjustable handle
(3) and hold.
1. Push in the two tabs on the edge of the
spool cover and pull to remove the cover
revealing the spool.
1. The line trimer has an automatic line feed
system which will automatically feed line
as you pull the trigger. Each time you pull
the trigger, a preset amount of line is fed.
2. While holding the top half, rotate the
bottom half of the shaft adjustment collar
anti-clockwise until it clicks into place.
This is now in the 180° position.
2. Pull the spool out. Feed the end of the new
line into the small slot at the base of the
spool. Wind the new line in the direction
mentioned on the spool (clockwise if
reading the text) ensuring that it is wound
as neatly as possible. Ensure the wound
line does not exceed the width of the spool.
2. You can adjust the length of the cutting
line between two options, 30cm and
25cm. To adjust the length, push the
swatch selector (8) fully down and rotate
it towards the designated length. When
rotating, ensure selector is rotated
towards the safety guard.
3. To rotate the shaft back to the 0° position,
do the same but rotate the bottom half of
the shaft clockwise.
3. When there is 300mm left of unwound
line, re-install the spool and feed the
unwound line through the eyelet. Finally,
replace the spool cover by pushing it
back onto the unit.
3. If you need to manually lengthen the line,
push the button on the side of the spool
cover (11) and pull line to desired length.
Each push of the button will release a
small section of line.
250MM/10” OR
300MM/12”
CUTTING SWATCH
SELECTION
1. PULL
2. ROATAE
0.
250MM/10” OR
300MM/12”
CUTTING SWATCH
SELECTION
1. PULL
2. ROATAE
0.
250MM/10” OR
300MM/12”
CUTTING SWATCH
SELECTION
1. PULL
2. ROATAE
0.
250MM/10” OR
300MM/12”
CUTTING SWATCH
SELECTION
1. PULL
2. ROATAE
0.
220210
250MM/10” OR
300MM/12”
CUTTING SWATCH
SELECTION
1. PULL
2. ROATAE
0.
250MM/10” OR
300MM/12”
CUTTING SWATCH
SELECTION
1. PULL
2. ROATAE
0.
WARNING
REMOVE BATTERY BEFORE PERFORMING ANY ADJUSTMENTS
