2. Attach white quick connect insert (B) to the "short" section of hose. Attach white quick con-
nect body (A) to the "long" section of the cut hose. Connect them together. (Figure 3-1)
3. If a direct connect to hydration bladder is desired, install the second white connector (C) to
the end of the output hose. This will match with many popular hydration systems.
(Figure 3-2)
Option #2:
This configuration is ideal for pumping filtered water directly into hydration packs (such as
Camelbak). It allows quick filling without removing pack or bladder.
Note: Ensure quick connect fittings are correct size for your hydration pack drink hose (1/4"
inside diameter) before proceeding to Step 1.
1. Cut hydration pack drink hose at desired length (approximately 4 inches from end of drink
hose). See Figure 4-1
2. Connect white body (A) to long section of drink hose that attaches to hydration bladder.
3. Connect white insert (B) to short section of drink hose that attaches to bite valve.
4. Connect the second white insert (C) to end of water filter output hose.
5. To fill bladder, connect white insert (C) on output hose to white body (A) on drink hose. Fill.
Reconnect bite valve. See Figure 4-2
Figure 3-1
Figure 3-2
EN
Figure 4-1
Figure 4-2
(A)
(B)
(C)
(A)
(C)
(A)
(B)
(C)
8018522-0 Hiker-Hiker PRO Manual EU-11-Sprachen_CONTENT_103656-Katadyn-B-da1a
