Key Components
Product Set-up
The Pocket requires minimal set up. For best results, try out the Pocket before first field use to famil-
iarize yourself with its operation.
1)
Prefilter
The modular prefilter (Figure 2-1) is effective in still and running water. It consists of two
components: a strainer and a weight. The prefilter is important because it prevents large
particles (larger than 130 microns) from entering the water system. See Field Performance
Tips for helpful hints.
2)
Connect Hoses
Push the hose float on to the input hose (hose with prefilter). Position the float approx. 2 inch-
es from prefilter. Attach the input hose to the input barb on the pump base. Push the bottle
clip on to the output hose. Attach the output hose to the output barb. (Figures 1-1, 2-1, 2-2)
3)
Flush System
Important: Before first use, flush system by pumping approximately 0.5 litres of water
through the unit to remove harmless ceramic dust. See following section on Normal
Operation on how to filter water.
Normal Operation
1)
Place input hose in untreated water source. Adjust the float to keep prefilter off the bottom
and away from sediment.
2)
Attach the bottle clip on the output hose on to a clean water container*. (Figure 2-3)
G
B
X >
X
Y
(Figure 2-3)
Ceramic Element
Measuring Gauge
Output Barb
Output Hose
Bottle Clip
Input Barb
Pump Base
(Figure 2-2)
8013888-3 Pocket Manual Content EU 11-sprachig_Manual EU 19.09.2012 08:32 Seite 3
(Figure 2-1)
Strainer
Float
Input Hose
