3
Fig 3
Fig 4
4. Cable tie the main power cord after the junction
box to the opposite side of the float where you cable
tied the fountain power cord. This will help provide
strain relief to junction box and puck lights if the cord
is accidentally pulled. (Fig 5)
Fig 5
Fig.1
Mounting to Fountain model 2400SF (xStream)
2. There are 8 circular indents on the float of the
2400SF xStream fountain. Make sure these areas are
clean, free of debris, and dry. Remove the backing
from one of the dual lock squares and stick to the
bottom of one of the indents (See Fig. 2). Repeat to
the other 7 indents of the float.
Fig 2
3. Place the puck light that has the power cord leading
to the junction box in the indent on the float that has a
notch for power cords. This would be the same area
where the power cord for the fountain is located. Push
down gently until the puck light snaps in place (Fig 3).
Place the other puck lights in the float and gently snap
them in place (Fig 4).
