2
THANKS
We at Kasco Marine, Inc. would like to both thank
and congratulate you on your purchase of the LED
Light Kit. This kit will illuminate your fountain for a
beautiful display. We thank you for choosing Kasco
for your fountain and aeration needs and want you to
be completely satisfied with your purchase.
Important Safety
Please read and follow these extremely important
safety and handling instructions for your Kasco
equipment. Following these instructions will help
ensure your safety and the quality performance of your
equipment.
•
Under NO circumstances should anyone enter
the water with the electrical equipment plugged
in and/or in operation. All Kasco equipment is
designed and built for use in water, and control
panels are available with GFCI protection.
However, it is NEVER recommended to enter the
water with the equipment in operation.
•
Kasco’s Light Kit is intended for use with a Listed
control panel having a GFCI protected receptacle,
or field wiring terminals and disconnect switch,
or a timer with a disconnect for use with a GFCI
receptacle. They are intended to be mounted on
a floating fountain or aerator for use in a natural
or man-made body of water to comply with NEC
Article 682.
•
Kasco’s Light Kit has not been evaluated for use in
swimming pools, spas or stationary fountains.
•
The power connection for the light kit is 120Vac
and MUST be plugged into a GFCI protected
receptacle or GFCI protected field terminal
connections.
•
Caution should be used when dealing with any
electrical and/or moving equipment.
•
NEVER run the unit out of water. It could create a
dangerous situation for the operator.
•
Extreme caution should be used around water,
especially cold water, as in Spring, Fall, and
Winter, which poses a hazard itself.
•
NEVER lift or drag the fountain or light kit by the
power cords. If you need to pull the unit to the
side of the pond, use the anchoring ropes.
•
Do not use waders in ponds/lakes that are deep,
with drop-offs, drastic slopes, or soft bottom
material.
•
Do not use a canoe or boat that tips easily during
installation
•
To reduce the risk of electrical shock, be certain
the light kit is connected to the GFCI protected
lighting circuit of your control panel. For
more information regarding your control panel
instructions, refer to your fountain owner’s manual
or download control panel wiring diagrams from
http://kascomarine.com/instructions.html. A
control panel must be installed a minimum of 5
feet (3m in Canada) from the body of water unless
separated from the body of water by a fence, wall,
or other permanent barrier that will make the unit
inaccessible to persons in the water.
General Instructions
INSPECT THE SHIPMENT
Immediately inspect this shipment for any visible
damages. Also cross reference the “Parts Included”
section to check for part shortages. Shortages should
be reported immediately to your Kasco Marine
distributor or representative and damages reported to
your carrier and Kasco Marine.
Parts Included
LED8012
•
A. Light Kit power cord with junction box (1)
•
B. 8 puck lights (1) (color depends on purchase)
•
C. Dual Lock Fastener Squares (16)
•
D. Cable tie (1)
Note: Part A and B are already connected.
TOOLS & SUPPLIES NEEDED
•
A. Diagonal Pliers or Cutter for Nylon Cable Tie
LED8012 Assembly Instructions
For ease of assembly, make sure the Aerating Fountain
is completely assembled. Place the assembly upright.
1. Unbundle the 8 puck light kit. Unpeel the back-
ing from one of the dual lock squares and place on the
back of one of the puck lights. (See Fig 1.) Repeat
this on the other 7 puck light fixtures.
