LED3C11, LED6C11 WATERGLOW COMPOSITE LIGHTING
MANUAL
884012 / 2021.1.1
8
Warranty Policy
Warranty period: LED3C11, LED6C11 = 3 year Limited Warranty:
Kasco® Marine, Inc. warrants this Light Kit to be free from de
-
fects in material or workmanship under normal use and service.
The Kasco Marine, Inc. obligation under this warranty is limited
to replacing or repairing free of charge any defective part within
the warranty period from the date of shipment� Customer shall
pay shipping charges for returning the unit to Kasco�
THIS WARRANTY IS IN LIEU OF ANY OTHER WARRANTIES,
EXPRESSED OR IMPLIED, AND ANY OTHER OBLIGATION
OR LIABILITY WHATEVER ON THE PART OF KASCO MA-
RINE, INC. AND IN NO EVENT SHALL KASCO MARINE, INC.
BE LIABLE FOR ANY SPECIAL OR CONSEQUENTIAL DAM-
AGES�
Warranty is void if:
• The Light Kit is not maintained properly according to the
Maintenance Recommendations supplied in this Manual�
•
The lights, control box, or power cord are altered in any
way from original shipment� Cuts in the power cord are not
covered under warranty.
•
The Light Kit is damaged by unauthorized tampering.
Warranty Claim Procedure:
The best method for establishing warranty period is by keeping
your original receipt and registering the equipment online at
under the
Once warranty coverage has been established, the light kit may
be sent to Kasco Marine or any Kasco Authorized Repair Center
for evaluation and repair.
WARRANTY
MAINTENANCE RECOMMENDATIONS
Under NO CIRCUMSTANCE should anyone enter the water
while a fountain is operating�
The following maintenance procedures can be utilized to ensure
many years of quality performance from your Kasco fountain and
light kit and reduce the need for more costly repair work� Note
that the LED fixtures are sealed and do not require any mainte
-
nance other than cleaning. Do not attempt to open light fixtures,
as this will void the warranty.
PROPER INSTALLATION: Installation of the LED light fixtures
on aerating fountain units with the mounting brackets oriented as
shown will ensure proper submersion of the light fixtures. Each
fixture must be partially submerged in order for lights to operate
properly. Other applications for these fixtures must provide at
least the same submersion to properly cool the fixture.
Operat
-
ing the fixtures out of water will damage the LED and void
warranty.
Proper installation of Kasco equipment will include
a power source with ground fault protection� The control panel
included with the equipment has built-in ground fault protection
for both the fountain and the lighting kit� Ground fault interrupters
are a safety feature that can also alert you to electrical leaks in
the equipment. If you have repeat, consistent trips of the ground
fault device, the equipment should be disconnected and removed
from the water� The power cord should be inspected for dam-
age and you should contact your distributor or contact Kasco
Marine at 715-262-4488 or [email protected] for further
instructions� A complete list of control panels can be found in the
section of
OBSERVATION: Operating equipment should be observed on a
regular basis (daily, if possible) for any reduction or variation in
performance. If a change in performance is observed, the equip
-
ment should be disconnected from power and inspected�
WINTER STORAGE: In regions where there is significant freez
-
ing in the wintertime, the light kit should be removed from the
water to protect it from the expansion pressure of ice. Storage
over winter is best in a location that is out of the sun and cool, but
above 32° F.
CLEANING: Light kits should be removed from the water at least
once per year (at the end of the season in cold climates) to clean
the exterior of the system. The light fixture surfaces dissipate
heat into the water, and any algae, calcium, or other build-up
will become an insulator that blocks heat transfer and may lead
to overheating and damage. Keeping the lenses clean will also
ensure the brightest light possible�
Back to Contents
